Vulcan Hart FP-024-50
COUPLING REDUCING 1-1/2 TO 1/2
SKU: VHFP-024-50
Condition: NEW
A coupling is a device used to connect two shafts together at their ends for the purpose of transmitting power. The primary purpose of couplings is to join two pieces of rotating equipment while permitting some degree of misalignment or end movement or both. In a more general context, a coupling can also be a mechanical device that serves to connect the ends of adjacent parts or objects. Couplings do not normally allow disconnection of shafts during operation, however there are torque limiting couplings which can slip or disconnect when some torque limit is exceeded. Selection, installation and maintenance of couplings can lead to reduced maintenance time and maintenance cost.
Alternatively, in plumbing or with tubing a coupling connects two pipes. If their sizes differ, the fitting is known as a reducing coupling, reducer, or an adapter. There are two types of couplings: "regular" and "slip". A regular coupling has a small ridge or stop internally, to prevent over-insertion of a pipe, and thus under-insertion of the other pipe segment (which would result in an unreliable connection). A slip coupling (sometimes also called a repair coupling) is deliberately made without this internal stop, to allow it to be slipped into place in tight locations, such as the repair of a pipe that has a small leak due to corrosion or freeze bursting, or which had to be cut temporarily for some reason.
A reducer changes the size of a pipe from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The length of the reduction is usually equal to the average of the larger and smaller pipe diameters. Although reducers are usually concentric, eccentric reducers are used as needed to maintain the top or bottom of pipe level.
Speed reducers are mechanical devices that help drive systems (motors) maintain optimal speed and torque for the application. Also known as gearboxes and gear drives, they lower the speed of rotation of the input shaft by a certain ratio and increase the power transmitted to the output shaft by the same ratio. Ratio multipliers increase the speed reduction and torque supplied by a speed reducer by a certain ratio and are suitable for parallel setups. Mounting bases, torque arms, and flange couplings are accessories used with speed reducers. They are often used in applications where the speed reducer will not be directly attached to the drive mechanism.
Masterful design. Precision performance. State-of-the-art innovation. For more than 150 years, Vulcan has been recognized by chefs and operators around the world as the best-in-class supplier for top-quality, energy-efficient foodservice equipment. Professionals trust Vulcan restaurant equipment to produce spectacular culinary results each and every time.
HTS Category Code: 8208.30.00
UNSPC Category Code: 48100000
NAICS Code: 333241
Manufacturer Code: VH
Width: 2.6 in (6.6 cm)
Height: 2.5 in (6.35 cm)
Length: 2.6 in (6.6 cm)
Unit of Measure: Each (EA)