Cma Dish Machines 04103.17
DRAIN VALVE SEAL WASHER -RUBBE
SKU: CMA04103.17
Condition: NEW
A drain is a channel, conduit, or pipe designed to carry away or channel superflous liquids for disposal or reclamation. A drain assembly is one or more components of a larger mechanism that facilitates as a drain. A drain assembly component may be a pipe, stopper, pan, basket, valve, filter, plug, hose etc.
A mechanical seal is a device that helps join systems or mechanisms together by preventing leakage (e.g. in a pump system), maintaining temperature, containing pressure, or excluding contamination. The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets or o-rings.
Valves are widely used in different restaurant equipment designs. A valve is a device that regulates, directs or controls the flow of a fluid (gases, steam, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways. In an open valve, fluid flows in a direction from higher pressure to lower pressure.
Valves may be operated manually, either by a handle, lever, pedal or wheel. Valves may also be automatic, driven by changes in pressure, temperature, or flow, allowing control over a variety of operational requirements.
A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Spring washers, which have axial flexibility are used to prevent fastening or loosening due to vibrations. Locking (lock) washers prevent fastening or loosening by preventing unscrewing rotation of the fastening device.
CMA began in a small building of 2500 square feet of manufacturing area in Westminster, California and today they build commercial warewashing equipment in a 100,000 square feet manufacturing area. CMA has always strived to be at the leading edge by offering reliable service, creative ideas, innovative designs and quality equipment. Today CMA produces both High-temperature and Low-temperature chemical sanitizing Dishmachines, Glasswashers and Warewashing equipment in Garden Grove, California.
HTS Category Code: 8208.30.00
UNSPC Category Code: 48100000
NAICS Code: 333241
Manufacturer Code: CMA
Width: 0.45 in (1.14 cm)
Height: 0.15 in (0.38 cm)
Length: 0.5 in (1.27 cm)
Unit of Measure: Each (EA)